Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2008CSX BASE, K20Z1REPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMELECTRONIC THROTTLE CONTROL SYSTEMACCELERATOR PEDAL MODULE REMOVAL/INSTALLATIONREMOVAL (K20Z3 ENGINE)
2008 Acura CSX Base, K20Z1
Removal (K20Z3 engine)
2008 Acura CSX Base, K20Z1SECTION Removal (K20Z3 engine)
- Disconnect the accelerator pedal module connector (A), then remove the nuts (B).
- Push the tab (C).
- Pry the accelerator pedal module to right and left, and remove the accelerator pedal module (D).NOTE:
- The APP sensor is not available separately. Do not disassemble the accelerator pedal module.
- If the tab or tab receivers (E) are damaged, pull back the carpet, remove the nut (F), and replace the pedal stop (G).
- If the tabs (H) of the accelerator pedal module are damaged, replace the accelerator pedal module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.