Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2008CSX BASE, K20Z1REPAIR AND DIAGNOSISBODY & FRAMEWINDOWSPOWER WINDOWSRESETTING THE POWER WINDOW CONTROL UNIT
2008 Acura CSX Base, K20Z1
Resetting the Power Window Control Unit
2008 Acura CSX Base, K20Z1SECTION Resetting the Power Window Control Unit
Resetting the driver's power window is required when any of the following have occurred:
- Power window regulator replacement or repair
- Power window motor replacement or repair
- Window run channel replacement or repair
- Driver's door glass replacement or repair
- Power is removed from the power window control unit while the power window timer is ON.
- Turn the ignition switch ON (II).
- Move the driver's window all the way down by using the driver's window DOWN switch.
- Open the driver's door.NOTE: Steps 4- 7 must be done within 5 seconds of each other.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.