Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2007TSX AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSELECTRONIC THROTTLE CONTROL SYSTEMTHROTTLE ACTUATOR CONTROL MODULE REPLACEMENT
2007 Acura TSX Automatic
Throttle Actuator Control Module Replacement
2007 Acura TSX AutomaticSECTION Throttle Actuator Control Module Replacement
- Remove the right kick panel (see TRIM REMOVAL/INSTALLATION - DOOR AREAS ).
- Push the tab (A) and disconnect the throttle actuator control module 16P connector (B).
- Remove the bolts (C), and the throttle actuator control module (D).
- Install the parts in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.