Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Acura TSX AutomaticFACTORY OEM SERVICE PROCEDURE
Passenger's Power Window Switch Test/Replacement
- Carefully pry off the door switch trim (see FRONT DOOR PANEL REMOVAL/INSTALLATION ).
- Disconnect the power window switch connector (A), then remove the three mounting screws and the power window switch (B) from the switch trim (C).
Front Passenger's:
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Rear:
- Swap the power window switch with another known-good switch and test. If the original power window switch is faulty, replace it.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.