2007 Acura TL BaseFACTORY OEM SERVICE PROCEDURE

Key Interlock Solenoid Test

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) in the SRS before doing repairs or service.

  1. Remove the driver's dashboard lower cover (see DRIVER'S DASHBOARD LOWER COVER REMOVAL/INSTALLATION ) and the lower steering column cover.
  2. Disconnect the steering lock assembly connector.
  3. Insert the ignition key in the key cylinder, then turn the ignition key to ACCESSORY (I).
  4. Connect a jumper wire from the battery positive terminal to steering lock assembly connector terminal No. 4, and connect another jumper wire from the battery negative terminal to No. 3 terminal. Make sure that the ignition key cannot be turned to LOCK (0) position. Disconnect the battery terminals, and make sure that the key can be turned to LOCK (0) position and removed from the cylinder.
    Fig 1: Connecting Jumper Wire From Battery Positive Terminal To Steering Lock Assembly Connector Terminal No. 4
    G05459161Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. If the key interlock solenoid works improperly, replace the ignition key cylinder/steering lock assembly (see STEERING LOCK REPLACEMENT ).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.