Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Acura TL BaseFACTORY OEM SERVICE PROCEDURE
Fuel Tank Replacement: Removal
- Relieve the fuel pressure (see FUEL PRESSURE RELIEVINGΒ ).
- Drain the fuel tank (see FUEL PRESSURE TESTΒ ).
- Install the fuel tank unit, if not already done.
- Loosen the rear wheel nuts slightly, then raise the vehicle, and make sure it is securely supported. Remove the rear wheels.
- Release the parking brake.
- Remove the fuel tank covers (A).
- Remove the exhaust muffler (see EXHAUST PIPE AND MUFFLER REPLACEMENT ).
- Disconnect the fuel fill neck tube (A) and breather hose (B).
- Disconnect the vapor line (A) from the EVAP canister (B). Then disconnect the fuel line (C).
- Disconnect the wheel sensor 2P connector (A).
- Remove the two caliper bolts (A), and caliper body (B).
- Remove the brake hose mounting bolt (A).
- Hook the caliper body (A) on to the damper spring (B).
- Remove the brake pads (see REAR BRAKE PAD INSPECTION AND REPLACEMENT ).
- Remove the parking brake cable (see PARKING BRAKE CABLE REPLACEMENT ).
- Remove the damper lower mounting bolt (A).
- Remove the parking brake cable bracket bolt (A).
- Remove the heat shield (A). Place a jack or support under the suspension subframe. Remove the mounting bolts (B) and (C). Remove the rear suspension subframe.
- Remove the bolts (A) and the fuel tank straps (B).
- Lift the fuel tank out of the subframe.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
