2007 Acura TL BaseFACTORY OEM SERVICE PROCEDURE

Enable Conditions

  1. Stuck at Low temperature
    ENABLE CONDITIONS

    Condition Minimum Maximum
    Engine coolant temperature 158°F (70°C) -
    Initial engine coolant temperature - 95°F (35°C)
    ATF temperature - -4 °F (-20°C)
    Vehicle speed 19 mph (30 km/h) -
    Battery voltage 11.0 V -
    Throttle position 4.0 ° -
    No active DTCs P0116, P0117, P0118, P0712, P0713, P0721, P0722
    Other After the engine coolant temperature reaches the set value, both the vehicle speed and the throttle position meet the conditions for 5 minutes or more
  2. Stuck at High temperature
    ENABLE CONDITIONS

    Condition Minimum Maximum
    Engine coolant temperature 158°F (70°C) -
    Previous engine coolant temperature when the ignition switch was turned OFF 158°F (70°C) -
    Present engine coolant temperature when the ignition switch is turned ON - 95°F (35°C)
    ATF temperature 230°F (110°C) -
    Battery voltage 11.0 V -
    No active DTCs P0116, P0117, P0118, P0712, P0713, P0721, P0722
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.