Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Acura TL BaseFACTORY OEM SERVICE PROCEDURE
Enable Conditions
ENABLE CONDITIONS
| Condition | Minimum | Maximum | |||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Engine coolant temperature | 14°F (-10°C)(1) | - | |||||||||||||
| 68°F (20°C)(2) | |||||||||||||||
| Engine speed | 500 rpm | 6,800 rpm | |||||||||||||
| MAP value(3) | 500 rpm | 19 kPa (5.7 in.Hg, 143 mmHg)(6) | - | ||||||||||||
| 23 kPa (6.7 in.Hg, 170 mmHg)(5) | |||||||||||||||
| 23 kPa (6.8 in.Hg, 172 mmHg)(4) | |||||||||||||||
| 2,000 rpm | 20 kPa (5.8 in.Hg, 146 mmHg)(6) | - | |||||||||||||
| 22 kPa (6.5 in.Hg, 165 mmHg)(5) | |||||||||||||||
| 2,500 rpm | 22 kPa (6.5 in.Hg, 163 mmHg)(4) | - | |||||||||||||
| Fuel feedback | Other than during fuel cut-off operation | ||||||||||||||
| No active DTCs | P0107, P0108, P0117, P0118, P0122, P0123, P0222, P0223, P0335, P0339, P0385, P0389, P1128, P1129, P2227, P2228, P2229 | ||||||||||||||
| Other | Test-drive on a flat road to avoid misdetection | ||||||||||||||
|
|||||||||||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.