Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Acura TL BaseFACTORY OEM SERVICE PROCEDURE
Rear Power Window Motor Test
- Remove the rear door panel (see FRONT DOOR WEATHERSTRIP REPLACEMENT ).
- Disconnect the 6P connector from the power window motor.
- Test the motor by connecting battery power and ground according to the table. When the motor stops running, disconnect one lead immediately.
- If the motor does not run or fails to run smoothly, replace it.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.