2007 Acura TL BaseFACTORY OEM SERVICE PROCEDURE

Power Relay Test: Notes

Use this chart to identify the type of relay, then do the test listed for it.

NOTE: For the turn signal/ hazard relay input test (see TURN SIGNAL/HAZARD RELAY INPUT TEST ).
POWER RELAY REFERENCE

Relay Test
Accessory power socket relay Normally-open type
A/C compressor clutch relay
A/C condenser fan relay
A/ F sensor relay
Blower motor relay
Daytime running lights relay
Fog light relay
Ignition coil relay
PGM-FI main relay 1, 2
Power window relay
Radiator fan relay
Rear window defogger relay
Seat heater relay
Starter cut relay 1, 2(1)
Throttle actuator control module relay
ACC cut relay (1) Five-terminal type
Fan control relay
IG2 cut relay (1)
(1) A/T
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.