2007 Acura RLFACTORY OEM SERVICE PROCEDURE

Hard Key

WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.

This diagnostic tests the joystick, and the buttons that surround it. For this model, the joystick and buttons do not use the GA-Net bus for communications.

To complete the test, touch each button or the vehicle's control panel, and move the joystick to each indicated position. As you test each function, the corresponding button on the display should highlight. To exit, push in and hold the selector knob.

Fig 1: Diagnostic Menu Screen Display - Hard Key
G05463213Courtesy of AMERICAN HONDA MOTOR CO., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.