Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Acura RLFACTORY OEM SERVICE PROCEDURE
Forced Starting of Display
WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools Required
SCS Service Connector 07PAZ-0010100
- Remove the right trunk side trim panel (see TRIM REMOVAL/INSTALLATION - TRUNK AREA ).
- Turn the ignition switch to LOCK (0), and connect the SCS service connector (A) to the navigation service check connector (B) located upper of the navigation unit.
- Turn the ignition switch to ON (II), and check that the diagnosis menu for the picture diagnosis starts up, and then changes to the system link menu.NOTE: If the display fails to display the Navi System Link screen, refer to no picture is displayed troubleshooting (see NO PICTURE IS DISPLAYED ).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
