Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Acura RLFACTORY OEM SERVICE PROCEDURE
DVD-ROM Replacement
WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Check any official Honda service web site for more service information about the navigation system.
- Turn the ignition switch to ON (II).
- Open the cover (A) on the right side of the trunk to gain access to the navigation unit.
- Press the EJECT button (B), then remove the DVD-ROM.
- Insert the new DVD-ROM with the white label facing up.
- Close the front cover. Do not turn the ignition switch to LOCK (0); watch the navigation screen until the data is down loaded to the navigation unit.
- Do the Map Matching (see MAP MATCHINGΒ
).NOTE: After servicing, the front cover and PC card slot door must be closed.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
