2007 Acura RLFACTORY OEM SERVICE PROCEDURE

Connected ECUs

WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.

Several ECUs are connected to each of the two networks. The gauge control module is part of both networks since it is the "gateway" between them. Here is a list of ECUs and the network they are connected to.

B-CAN ECUs 

  • Gauge control module
  • Relay control module
  • Multiplex integrated control unit (MICU)
  • Door multiplex control unit
  • Combination switch control unit
  • Display panel control unit
  • HandsFreeLink control unit
  • Power seat control unit
  • Automatic lighting control unit
  • AcuraLink control unit (XM receiver)

F-CAN ECUs 

  • Gauge control module
  • ECM/PCM
  • Navigation unit
  • VSA modulator-control unit
  • TPMS control unit
  • AcuraLink control unit (XM receiver)
  • SRS unit
    Fig 1: B-CAN ECUs And F-CAN ECUs Communication Diagram
    G05462611Courtesy of AMERICAN HONDA MOTOR CO., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.