2007 Acura RDXFACTORY OEM SERVICE PROCEDURE

DTC P2263: Turbocharger Boost System Performance Problem: General Description

This turbocharged engine is equipped with a mass air flow (MAF) sensor to measure the amount of intake air, a turbocharger boost sensor to measure boost pressure before the throttle, and a barometric pressure (BARO) sensor to measure atmospheric pressure.

Solenoids operate the turbocharger boost control valves. A turbocharger wastegate control valve, and a turbocharger bypass control valve are used to control boost pressure.

Boost pressure characteristics are compared to intake air volume before boost pressure control, and if it is beyond a set value it is diagnosed as a turbocharger boost system performance problem.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.