Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Acura MDXFACTORY OEM SERVICE PROCEDURE
Fuel Tank Replacement
- Relieve the fuel pressure (see FUEL PRESSURE RELIEVINGΒ ).
- Drain the fuel tank (see FUEL TANK DRAININGΒ ), then disconnect the fuel tank unit 4P connector and the quick-connect fittings from the fuel tank unit.
- Raise the vehicle on a lift.
- Remove the exhaust pipe (see EXHAUST PIPE AND MUFFLER REPLACEMENT ).
- Remove the propeller shaft (see PROPELLER SHAFT REMOVAL ), and support it with jackstands.
- Remove the fuel tank guard (A) and fuel tank protector (B).
- Loosen the clamp (C), and disconnect the tube (D). Slide back the clamps, then twist the hoses as you pull to avoid damaging them.
- Open the clamps (E).
- Disconnect the hoses (F).
- Place a jack or other support under the fuel tank (G).
- Remove the strap bolts and the straps (H).
- Remove the fuel tank.
- Install the parts in the reverse order of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
