Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2005TSX AUTOMATICREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTMEMORY MODULESDRIVER POSITION MEMORY SYSTEM (DPMS)DRIVING POSITION MEMORY SWITCH TEST/REPLACEMENT
2005 Acura TSX Automatic
Driving Position Memory Switch Test/Replacement
2005 Acura TSX AutomaticSECTION Driving Position Memory Switch Test/Replacement
- Remove the driver's door panel (see FRONT DOOR PANEL REMOVAL/INSTALLATION ).
- Disconnect the 12P connector from the memory switch.
- Remove the two screws, then remove the switch from the door panel.
- Check for continuity between the terminals in each switch position according to Fig 2.
- If the continuity is not as specified, replace the switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.