2005 Acura RLFACTORY OEM SERVICE PROCEDURE

Front Subframe Alignment

NOTE: Using the special tool, make the front suspension subframe alignment as the following sequence.
  1. Make the front suspension subframe (A) alignment.
    1. Lift the front suspension subframe up to the body, and loosely install the new subframe mounting bolts and the brackets (B).
    2. Insert the alignment pin (C) into the alignment hole in the right rear of the subframe, and then align the subframe with the body.
    3. Loosely tighten the subframe mounting bolt (D) at the right rear.
    4. Insert the alignment pin into the alignment hole in the left rear of the subframe, and then align the subframe with the body.
    5. Loosely tighten the subframe mounting bolt (E) at the left rear.
    6. Loosely tighten both front subframe mounting bolts (F).
    7. Insert the alignment pin into the alignment hole in the right rear of the subframe.
    8. Loosen the subframe mounting bolt at the right rear, and fit the lower insulator (G), in the subframe, and then tighten the mounting bolt to the specified torque values.
    9. Tighten the remaining subframe mounting bolts and the bracket mounting bolts (H) to the specified torque values.
      Fig 1: Identifying Front Subframe Components
      G05496526Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. After reinstalling all removed parts, check and adjust the front wheel alignment (see WHEEL ALIGNMENT ).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.