Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2004 Acura TL StandardFACTORY OEM SERVICE PROCEDURE

Fuel Tank Replacement: Installation

Install the tank straps (A), and tighten the bolts (B).

Fig 1: Installing Tank Straps
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Place a jack or support under the rear suspension subframe. Install the rear suspension subframe, aligning the pins (A) with the holes in the subframe.

Fig 2: Aligning Pins With Holes In Subframe
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the remaining parts in the reverse order of removal.
After installation, do a wheel alignment (see WHEEL ALIGNMENT ).

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.