Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Acura TL AutomaticFACTORY OEM SERVICE PROCEDURE
Park Pin Switch Replacement
- Remove the center console (see CENTER CONSOLE REAR SECTION REMOVAL/INSTALLATION ).
- Disconnect transmission gear selection switch/park pin switch connector (A), then remove the connector from the shift lever bracket base.
- Remove the A/T gear position indicator panel light bulb socket (B), then remove the bulb (C) from the socket.
- Remove the transmission gear selection switch/park pin switch (D) by releasing the lock tabs (E).
- Install the new switch assembly in the shift lever bracket base.
- Install the bulb in the socket, then install the socket in the bracket base.
- Install the switch connector on the bracket base, then connect the connector.
- Install the center console (see CENTER CONSOLE REAR SECTION REMOVAL/INSTALLATION ).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
