2004 Acura TL AutomaticFACTORY OEM SERVICE PROCEDURE

Rear Window Motor Test

  1. Remove the rear door panel (see REAR DOOR PANEL REMOVAL/INSTALLATION ).
  2. Disconnect the 6P connector from the window motor.
    Fig 1: Disconnecting 6P Connector From Window Motor
    G03662177Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Test the motor by connecting battery power and ground according to the table. When the motor stops running, disconnect one lead immediately.
    Fig 2: Rear Window Motor Test Table
    G03662178Courtesy of AMERICAN HONDA MOTOR CO., INC.

    ( ): Left rear window motor 

  4. If the motor does not run or fails to run smoothly, replace it.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.