Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Acura TL AutomaticFACTORY OEM SERVICE PROCEDURE
Passenger's Window Switch Test/Replacement: Rear
- Remove the rear door panel (see REAR DOOR PANEL REMOVAL/INSTALLATION ).
- Remove the screw and disconnect the connector (A) from the power window switch (B), then remove the switch assembly from the door panel.
- Remove the three mounting screws, then remove the power window switch from the switch panel.
- Swap the rear power window switch with another known-good switch and test. If the original window switch is faulty; replace it.
- Install in the reverse order of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.