Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2004TL AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMESEATSDRIVING POSITION MEMORY SYSTEMS (DPMS)POWER SEAT CONTROL UNIT INPUT TEST
2004 Acura TL Automatic
Power Seat Control Unit Input Test
2004 Acura TL AutomaticSECTION Power Seat Control Unit Input Test
NOTE:
Before troubleshooting the DPMS, troubleshoot the multiplex integrated control system first using B-CAN System Diagnosis Test Mode A (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A
).
- Turn the ignition switch OFF.
- Remove the driver's power seat (see FRONT SEAT REMOVAL/INSTALLATION
).NOTE: Be careful not to scratch the interior trim.
- Disconnect the connectors from the power seat control unit (A).NOTE: All connectors view are from wire side of female terminals.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.