2004 Acura TL AutomaticFACTORY OEM SERVICE PROCEDURE

Audio-HVAC Display Module Assembly Removal/Installation

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ), and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before performing repairs or service.

NOTE:
  • Put on gloves to protect your hands.
  • Take care not to scratch the dashboard and related parts.
  • Lay a workshop towel under the parts when working on them to protect the face panel from scratches or other damage.
  1. Make sure you have the anti-theft codes for the radio and navigation system, then write down the channels for the XM radio's presets.
  2. Remove the center console rear section (see CENTER CONSOLE REAR SECTION REMOVAL/INSTALLATION ) and center console panel (see CENTER CONSOLE PANEL REMOVAL/ INSTALLATION ).
  3. Remove the upper panel (see DRIVER'S DASHBOARD UNDER COVER REMOVAL/INSTALLATION ).
  4. Remove the screws and bolts, then pull out the audio-HVAC display module assembly (A).
    Fig 1: Identifying Audio-HVAC Display Module Assembly (A), Connectors (B) And Antenna Sublead (C)
    G03662470Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Disconnect the connectors (B) and antenna sublead (C), then remove the audio-HVAC display module assembly.
  6. Install the audio-HVAC display module assembly in the reverse order of removal, and note these items:
    • Make sure all connectors and antenna lead are secure.
    • Enter the anti-theft code for the radio, then enter the customer's XM radio channel presets, and set the clock.
    • If necessary, enter the navigation system anti-theft code.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.