2004 Acura TL AutomaticFACTORY OEM SERVICE PROCEDURE

Keyless Receiver Unit Input Test

  1. Remove the dashboard lower cover (see DRIVER'S DASHBOARD LOWER COVER REMOVAL/INSTALLATION ).
  2. Disconnect the 5P connector (A) from the keyless receiver unit (B).
    Fig 1: Disconnecting 5P Connector
    G03662064Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Inspect the connector and socket terminals to be sure they are all making good contact.
    • If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
    • If the terminals are OK, go to step Β 4.
  4. Reconnect the connector, and make these input tests at the connector.
    • If any test indicates a problem, find and correct the cause, then recheck the system.
    • If all the input tests prove OK, go to step Β 5.
    POSSIBLE CAUSE

    Cavity Wire Test condition Test: Desired result Possible cause if result is not obtained
    1 BLK Under all conditions Check for voltage to ground: There should be less than 1 V.
    • Poor ground (G501)
    • An open in the wire
    3 YEL Ignition switch ON (II) Check for voltage to ground: There should be battery voltage.
    • Blown No. 21 (7.5 A) fuse in the under-dash fuse/relay box
    • An open in the wire
    5 GRY/BLU Under all conditions Check for voltage to ground: There should be battery voltage.
    • Blown No. 6 (7.5 A) fuse in the under-dash fuse/relay box
    • An open in the wire
  5. Disconnect the 10P connector from the under-hood fuse/relay box, and make these input tests at the connector.
    • If any test indicates a problem, find and correct the cause, then recheck the system.
    • If all the input tests prove OK, the relay module must be faulty, replace the under-hood fuse/relay box.
    POSSIBLE CAUSE

    Cavity Wire Test condition Test: Desired result Possible cause if result is not obtained
    2 PNK/BLK Power window master switch connector A (22P) disconnected Check for continuity between the No. 2 terminal and the power window master switch connector A terminal No. 16:
    There should be continuity.
    An open in the wire
    Check for continuity between No. 2 terminal and body ground:
    There should be no continuity.
    A short to ground in the wire
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.