Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Acura MDX BaseFACTORY OEM SERVICE PROCEDURE
A/C System Inspection
WARNING: This page is about a different car, the 2009 Acura MDX, 2008 Acura MDX, and 2007 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
Before troubleshooting any problem with the air conditioning system, do the following:
- With the ignition switch in the LOCK (0), inspect the A/C components, pressure lines and hoses for stains that may indicate a refrigerant or a compressor oil leak.
- Check the condenser for material clogging the fins or for damage to the fins:
- Carefully clean any material from the condenser fins with water and detergent.
- Be sure to dry the condenser completely.
- Inspect the drive belt (see DRIVE BELT INSPECTION ).
- Make sure no material is blocking the airflow to the condenser.
- Check the dust and pollen filter, and replace it if it is clogged (see DUST AND POLLEN FILTER REPLACEMENTΒ ).
- Check the operation of the heater valve. Make sure the cable is adjusted properly (see HEATER VALVE CABLE ADJUSTMENTΒ ).
- Start the engine, turn the air conditioning system on, and allow it to normalize for a few minutes.
- Check that the A/C operates at each position of the blower fan switch (except OFF).
- Check that the compressor clutch is engaged. The pressure plate should be rotating at the same speed as the pulley.
- Check that the cooling fans operate when the compressor clutch is engaged.
- Check that the engine idle speed is correctly maintained when the A/C is switched on and off when the compressor clutch is engaged and disengaged.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
