2004 Acura MDX BaseFACTORY OEM SERVICE PROCEDURE

Voice Control Switch Test

WARNING: This page is about a different car, the 2009 Acura MDX, 2008 Acura MDX, and 2007 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the driver's airbag assembly (see DRIVER'S AIRBAG REPLACEMENT ).
  2. Remove the 20P connector from the cable reel.
    Fig 1: Identifying Voice Control Switch Connector Terminals
    G05488686Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Measure the resistance between the No. 8 and No. 10 terminals in each switch position according to the table.
    RESISTANCE CHART

    Position Resistance
    No buttons pressed About 10 kΞ©
    Talk button pressed About 2.2 kΞ©
    Back button pressed About 640 Ξ©
  4. If the resistance is not as specified, replace the voice control switch (see STEERING WHEEL DISASSEMBLY/REASSEMBLY ).
  5. Use a diode tester between the terminals in each switch position according to the table.
    Fig 2: Checking For Continuity Between Terminals In Each Switch Position
    G05488687Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. If the diode test is not as specified, replace the voice control switch (see STEERING WHEEL DISASSEMBLY/REASSEMBLY ).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.