2004 Acura MDX BaseFACTORY OEM SERVICE PROCEDURE

Navigation Unit Inputs and Outputs for Connector F (5P)

WARNING: This page is about a different car, the 2009 Acura MDX, 2008 Acura MDX, and 2007 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Navigation Unit Connector F (5P) Terminals
G05488611Courtesy of AMERICAN HONDA MOTOR CO., INC.

Navigation Unit Connector F (5P) With AcuraLink 

NAVIGATION UNIT CONNECTOR F (5P) TERMINAL REFERENCE - WITH ACURALINK

Terminal Number Wire Color Terminal Name Description Voltage (about) Symptom
1 WHT HFL COMM3 (HFL communication 3) Communication signal for HFL 5 V DC Solid red HFL icon in Navi System Link
2 RED HFL COMM4 (HFL communication 4) Communication signal for HFL 4.5 V DC Solid red HFL icon in Navi System Link
3 GRN HFL COMM1 (HFL communication 1) Communication signal for HFL 5 V DC HFL icon in Navi System Link changes between red and green
4 BLK HFL COMM2 (HFL communication 2) Communication signal for HFL 4.5 V DC HFL icon in Navi System Link changes between red and green
5 BRN(1) SH HFL (Shield HFL) Shield for No. 1, 2, 3, 4 terminals 0 V --
(1) The shielded wires have a heat-shrunk tube insulating the outside of the wire. The color of the insulating tube, typically black or dark gray, may not match the color of the wire listed on the schematic.

Navigation Unit Connector F (5P) Without AcuraLink 

NAVIGATION UNIT CONNECTOR F (5P) TERMINAL REFERENCE - WITHOUT ACURALINK

Terminal Number Wire Color Terminal Name Description Voltage (about) Symptom
1 RED HFL COMM3 (HFL communication 3) Communication signal for HFL -- Solid red HFL icon in Navi System Link
2 WHT HFL COMM4 (HFL communication 4) Communication signal for HFL -- Solid red HFL icon in Navi System Link
3 GRN HFL COMM1 (HFL communication 1) Communication signal for HFL -- HFL icon in Navi System Link changes between red and green
4 BLK HFL COMM2 (HFL communication 2) Communication signal for HFL -- HFL icon in Navi System Link changes between red and green
5 BRN(1) SH HFL (Shield HFL) Shield for No. 1, 2, 3, 4 terminals -- --
(1) The shielded wires have a heat-shrunk tube insulating the outside of the wire. The color of the insulating tube, typically black or dark gray, may not match the color of the wire listed on the schematic.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.