Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Acura MDX BaseFACTORY OEM SERVICE PROCEDURE
Navigation Unit Inputs and Outputs for Connector D (7P)
WARNING: This page is about a different car, the 2009 Acura MDX, 2008 Acura MDX, and 2007 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
Navigation Unit Connector D (7P)Β
NAVIGATION UNIT CONNECTOR D (7P) TERMINAL REFERENCE
| Terminal Number | Wire Color | Terminal Name | Description | Voltage (about) | Symptom | ||
|---|---|---|---|---|---|---|---|
| D1 | WHT | CAMERA VCC (VCC supply) | Power source for rearview camera | 7V | If open: No rearview camera image. If short to ground: When put into reverse, the navigation screen goes black (backlight still operative). NOTE: If this wire is shorted to ground, the navigation unit can be permanently damaged. |
||
| D5 | BLK | VIDEO (Video camera) | Video signal for rearview camera | 0.3 V | If open: No rearview camera image. If short to ground: When put into reverse, the navigation screen goes black (backlight still operative). NOTE: If this wire is shorted to ground, the navigation unit can be permanently damaged. |
||
| D6 | GRY(1) | CAMERA SH (Shield and ground for camera) | Shield for terminal No. 1 to No. 7 | 0 V | If open: No rearview camera image. If short to ground: No change to rearview camera image. NOTE: If this wire is shorted to ground, the navigation unit can be permanently damaged. |
||
| D7 | RED | CAMERA ADPT (Adaptive camera) | Control signal for rearview camera | 0 V | If open: No change to rearview camera image. If short to ground: No change to rearview camera image. NOTE: If this wire is shorted to ground, the navigation unit can be permanently damaged. |
||
|
|||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
