Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Acura MDX BaseFACTORY OEM SERVICE PROCEDURE
Navigation Unit Removal/Installation
WARNING: This page is about a different car, the 2009 Acura MDX, 2008 Acura MDX, and 2007 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Before you replace the navigation unit, back-up the client data using system diagnostic mode save users memory under the functional set up (see SAVE USERS MEMORY ).
- If the navigation unit is replaced or disconnected, a Map Matching must be done (see MAP MATCHING ).
- Turn the ignition switch to ON (II).
- Eject the DVD from the original navigation unit (see DVD-ROM Replacement
). To avoid scratching or damaging the DVD, temporarily place the DVD in a jewel case.NOTE: If the DVD will not eject, refer to symptom troubleshooting Navigation unit will not eject or accept the navigation DVD (see NAVIGATION UNIT WILL NOT EJECT OR ACCEPT THE NAVIGATION DVD ).
- Turn the ignition switch to LOCK (0).
- Remove the Driver's seat (see FRONT SEAT ACTIVE HEAD RESTRAINT INSPECTION ).
- Remove the two mounting nuts (A) from the navigation unit (B).
- Remove the cover (C), then disconnect the navigation unit connectors (D).
- Remove the bolts, and the brackets (A).
- Install the unit in the reverse order of removal.
- Install in the reverse order of removal.
- Turn the ignition switch to ON (II), then reinstall the client's original DVD, verifying that the DVD is free of scratches or smudges.
- Check any official Honda service website for more service information about patches for the navigation system. Apply any prescribed patches to the new navigation unit.NOTE: Simply transferring the DVD from the original navigation unit to the new navigation unit does not assure the correct software for the vehicle will be loaded into the new navigation unit. Doing the DVD transfer without doing software patches may cause the new navigation unit to appear to be malfunctioning.
- Enter the new navigation anti-theft code.
- Park the vehicle outside, and do the GPS initialization (see GPS INITIALIZATION ).
- Give the new navigation anti-theft code to the client.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
