Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Passenger's Power Seat Motor
Remove passenger's seat. See FRONT SEATS under REMOVAL & INSTALLATION. Disconnect connectors from each power seat motor. Using fused jumper wires, apply battery voltage and ground to specified harness connector terminals. See PASSENGER'S POWER SEAT MOTOR OPERATION table. See Fig 1 . If any motor fails any portion of test, replace faulty motor.
| Application & Seat Movement | Connect Battery To Terminals (+) & (-) | |
|---|---|---|
| Slide Motor | ||
| Forward | 1 & 2 | |
| Backward | 2 & 1 | |
| Recline Motor | ||
| Forward | 1 & 2 | |
| Backward | 2 & 1 | |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.