Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Steering Pressure Switch Signal: RSX
2004 Acura 3.5RLSECTION RSX
- Turn ignition switch on. Measure voltage by backprobing between Gray 31-pin ECM/PCM harness connector terminal No. 24 (Brown/Yellow wire) and White 31-pin ECM/PCM harness connector terminal No. 20 (Light Green/Black wire). See Figure . See appropriate wiring diagram under ENGINE PERFORMANCE in WIRING DIAGRAMS. If voltage is less than one volt, go to next step. If voltage is one volt or more, go to step 3 .
- Start engine. Turn steering wheel to full lock. Measure voltage by backprobing between Gray 31-pin ECM/PCM harness connector terminal No. 24 (Brown/Yellow wire) and White 31-pin PCM harness connector terminal No. 16 (Light Green/Black wire). See Figure . If battery voltage is not present, go to next step. If battery voltage is present, Power Steering Pressure (PSP) switch signal is okay.
- Turn ignition switch off. Disconnect PSP switch 2-pin wire harness connector. Connect fused jumper wire between PSP switch 2-pin harness connector terminals. Turn ignition switch on. Measure voltage by backprobing between Gray 31-pin ECM/PCM harness connector terminal No. 24 (Brown/Yellow wire) and White 31-pin PCM harness connector terminal No. 16 (Light Green/Black wire). See Figure
. If voltage is less than one volt, replace PSP switch. If voltage is one volt or more check for following:
- An open in Light Green/Black wire between White 31-pin PCM harness connector terminal No. 16 and PSP switch 2-pin harness connector.
- An open in Black wire between ground terminal and PSP switch 2-pin harness connector.
Repair as necessary.
- Turn ignition switch off. Disconnect PSP switch 2-pin harness connector. Turn ignition switch on. Measure voltage by backprobing between Gray 31-pin ECM/PCM harness connector terminal No. 24 (Brown/Yellow wire) and White 31-pin ECM/PCM harness connector terminal No. 16 (Light Green/Black wire). See Figure . If battery voltage is not present, go to next step. If battery voltage is present, replace PSP switch.
- Turn ignition switch off. Disconnect White 31-pin ECM/PCM harness connector. Check continuity between ground and White 31-pin ECM/PCM harness connector terminal No. 16 (Light Green/Black wire). If continuity is present, repair short in Light Green/Black wire between White 31-pin ECM/PCM harness connector terminal No. 16 and PSP switch 2-pin harness connector. If continuity is not present, update PCM, if it does not have latest software or substitute known-good PCM, then recheck. If symptom or indication goes away, replace original PCM.
NOTE:
When substituting PCM, immobilizer code must be rewritten to replacement PCM using Honda PGM tester, or else engine will not start.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.