Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA20043.5RLREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALSTARTERSBENCH TESTINGOVERRUNNING CLUTCH TEST
2004 Acura 3.5RL
Overrunning Clutch Test
2004 Acura 3.5RLSECTION Overrunning Clutch Test
- Slide overrunning clutch along shaft. If overrunning clutch does not slide smoothly, replace overrunning clutch assembly. Rotate overrunning clutch on shaft. See Fig 1 . If clutch does not lock when rotated in one direction and rotates smoothly in other direction, replace overrunning clutch assembly.
- Check starter drive gear for wear or damage. If gear is damaged, replace overrunning clutch assembly. Drive gear is not available separately. Check starter drive gear teeth for wear or damage. If starter drive gear teeth are damaged, check condition of flywheel (M/T) or flexplate (A/T).
- Check the condition of the torque converter ring gear teeth are damaged.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.