SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2003MDX TOURINGREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTAUDIO SYSTEMRADIO REMOTE SWITCH TEST/REPLACEMENT'05-06 MODELS
2003 Acura MDX Touring

'05-06 Models

2003 Acura MDX TouringSECTION '05-06 Models
  1. Remove the driver's airbag assembly (see DRIVER'S AIRBAG REPLACEMENT ).
  2. Disconnect the 16P connector (A) from the cable reel.
    Fig 1: Disconnecting 16P Connector From Cable Reel
    G03642532Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Measure the resistance between the 16P connector No. 5 and No. 7 terminals in each switch position according to Fig 2 .
    Fig 2: Measuring Resistance Between 16P Connector Terminals 5 And 7 In Each Switch Position Chart
    G03642533Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. If the resistance is not as specified, go to step 5.
  5. Remove the two screws and the cruise control set/ resume/switch (B) from the steering wheel.
  6. Remove the four screws, the 1P connector (C) and the radio remote switch (D), HFL-voice control switch and cruise set/resume/cancel switch as an assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.