Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
'03 Model
2003 Acura MDX TouringSECTION '03 Model
- Turn the light switch OFF.
- Carefully pry off the lens (A) with a small screwdriver.
MAP LIGHT: 6.2 w x 2
- Remove the four mounting screws.
- Disconnect the 3P connector (B) from the housing (C).
- Check for continuity between the terminals.
- There should be continuity between the No. 1 and No. 3 terminals with the left switch ON.
- There should be continuity between the No. 1 and No. 2 terminals with the right switch ON.
- If the continuity is not as specified, check the bulb(s) (D). If the bulbs are OK, replace the light.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.