2003 Acura MDX BaseFACTORY OEM SERVICE PROCEDURE

Engine Electrical

ENGINE ELECTRICAL STANDARDS AND SERVICE LIMITS SPECIFICATION

Item Measurement Qualification Standard or New Service Limit
Ignition coil Rated voltage   12V
Firing order   1-4-2-5-3-6
Sparkplug Type   NGK:IZFR5K11
DENSO.-SKJ16DR-M11
Gap   1.0-1.1 mm (0.039-0.043 in.) -
Ignition timing At idle
Check the red mark
In N or P position 10+/-2°BTDC
Drive belt Tension   Auto tensioner
Alternator Output At 13.5 V and normal engine temperature 130 A
Coil (rotor) resistance At 68°F (20°C) 2.3-2.7 k Ω
Slip ring O.D.   14.2-14.4 mm (0.56-0.57 in.) 13.8 mm (0.54 in.)
Brush length   10.5 mm (0.41 in.) 1.5 mm (0.06 in.)
Brush spring tension   2.94-3.53 N (0.30-0.36 kgf, 0.66-0.80 lbf)
Starter Output   1.6 kW
Commutator mica depth   0.4-0.6 mm (0.016-0.024 in.) 0.20 mm (0.008 in.)
Commutator runout   0.05 mm (0.002 in.) max. 0.1 mm (0.004 in.)
Commutator O.D.   29.3-29.5 mm (1.154-1.161 in.) 28.8 mm (1.134 in.)
Brush length   7.7-8.0 mm (0.30-0.31 in.) 0.9 mm (0.04 in.)
Brush spring tension (new)   15.9-19.5 N (1.62-1.99 kgf, 3.57-4.39 lbf)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.