Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Acura MDX BaseFACTORY OEM SERVICE PROCEDURE
Door Unit
- Carefully pry off the driver's door switch trim (see FRONT DOOR PANEL REMOVAL/INSTALLATION ).
- Disconnect the connectors (A).
- Inspect the connector and socket terminals to be sure they are all making good contact.
- If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
- If the terminals look OK, go to step 4.
- Make the following input tests at connector A (20P).
- If any test indicates a problem, find and correct the cause, then recheck the system.
- If all the input tests prove OK, go to step 1 in DRIVER'S UNITΒ .
MULTIPLEX CONTROL UNIT INPUT TEST (DOOR UNIT)Cavity Wire Test condition Test: Desired result Possible cause if result is not obtained A1 WHT/RED Under all conditions Check for voltage to ground:
There should be battery voltage.- Blown No. 13 (7.5 A) fuse in the passenger's under-dash fuse/relay box
- Blown No. 54 (40 A) fuse in the under-hood fuse/relay box
- An open in the wire
A2 GRN/WHT Ignition switch ON (II) and passenger's multiplex terminal A12 connected to battery voltage Check for voltage to ground on A2:
There should be battery voltage.- Blown No. 15 (20 A) fuse in the passenger's under-dash fuse/relay box
- Faulty power window relay
- An open in the wire
A12(1) Fuse/relay box socket A12 BLK Under all conditions Check for continuity to ground:
There should be continuity.- Poor ground (G401)
- An open in the wire
B1 BLK Under all conditions Check for continuity to ground:
There should be continuity.- Poor ground (G601)
- An open in the wire
(1) Passenger's multiplex control unit connector A
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
