Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Acura MDX BaseFACTORY OEM SERVICE PROCEDURE
Power Relay Test: Notes
Use this chart to identify the type of relay, then do the test listed for it.
NOTE:
For the turn signal/hazard relay input test (see TURN SIGNAL/HAZARD RELAY INPUT TEST
).
RELAY POWER TEST
| Relay | Test |
|---|---|
| Accessory power socket relay | Normally-open type A |
| A/C compressor clutch relay | |
| A/C condenser fan relay | |
| A/F (air fuel ratio) sensor relay | |
| Dimmer relay | |
| Fog light relay | |
| Headlight relay 1 | |
| Headlight relay 2 | |
| High beam cut relay (Canada) | |
| Horn relay | |
| Ignition coil relay | |
| PGM-FI main relay 1 | |
| PGM-FI main relay 2 | |
| Power window relay | |
| Radiator fan relay | |
| Reverse relay | |
| Rear accessory power socket relay | |
| Rear stereo amplifier relay ('03 model) | |
| Seat heater relay | |
| Starter cut relay | |
| Taillight relay | |
| Throttle actuator control module relay | |
| VTM-4 relay | |
| Blower motor relay | Normally-open type B |
| Rear blower motor relay | |
| Rear window defogger relay | |
| Automatic wiper relay | Five-terminal type |
| Fan control relay | |
| Intermittent wiper relay | |
| Key interlock relay ('05-06 models) | |
| Moonroof open relay | |
| Moonroof close relay | |
| Shift lock relay |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
