2003 Acura 3.5RLFACTORY OEM SERVICE PROCEDURE

Steering Lock Assembly: Installation

  1. Insert the ignition key into the new steering lock body, and turn it to ACC position.
  2. Push the lock pin down, and insert the steering lock body into the steering column until it clicks into place.
  3. Loosely install new shear bolt.
  4. Make sure the steering wheel lock operates smoothly, and that the ignition key turns freely.
  5. Tighten the shear bolt until the hex head twists off.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.