2003 Acura 3.5RLFACTORY OEM SERVICE PROCEDURE

Shift Lock Solenoid

  1. Remove the center console panel. See CENTER CONSOLEΒ  under REMOVAL & INSTALLATION.
  2. Disconnect the shift lock solenoid harness connector. See Figure.
  3. CAUTION: Do not connect the shift lock solenoid No. 2 terminal (reverse polarity) to the battery positive terminal or you will damage the diode inside the solenoid.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.