2003 Acura 3.5RLFACTORY OEM SERVICE PROCEDURE

Using Malfunction Indicator Light (MIL)

NOTE: If No. 56 BACK UP RADIO (7.5 amp) fuse is removed and ignition switch is turned ON (II), MIL will come on and PCM will store DTC P0560.
  1. Locate 2-pin Service Check Connector behind glove box. See Fig 1 . Install SCS Service Connector (07PAZ-0010100) to Service Check Connector. Turn ignition switch ON (II). Observe MIL. Light indicates a Diagnostic Trouble Code (DTC) by number of flashes.
  2. Single-digit trouble codes (1-9) are indicated by individual short flashes. Double-digit trouble codes (10-59) are indicated by a series of long and short flashes. The number of long flashes equals first digit; the number of short flashes equals second digit. If any DTCs are retrieved, see DIAGNOSTIC TROUBLE CODE DEFINITIONSΒ  .
  3. To determine if code is a hard or intermittent fault, clear PCM memory and recheck for code to appear. See PCM RESET PROCEDURE/CLEARING DIAGNOSTIC TROUBLE CODESΒ  . If codes other than those listed appear, temporarily substitute a known-good PCM and retest system.
Fig 1: Installing SCS Service Connector Tool
G96C01345Courtesy of AMERICAN HONDA MOTOR CO., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.