2003 Acura 3.5RLFACTORY OEM SERVICE PROCEDURE

Pcm Location

CAUTION: When substituting a known-good PCM, immobilizer code must be rewritten to replacement PCM using Honda PGM tester, or engine will not start.

Remove right side door sill molding. Pull passenger side carpet back. Remove PCM cover. Connect test equipment using backprobe set. See TEST EQUIPMENTΒ  . Check system according to procedures described in specific Diagnostic Trouble Code (DTC) tests.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.