2003 Acura 3.5RLFACTORY OEM SERVICE PROCEDURE

Steering Angle Sensor Neutral Position Check & Memorizing: Check

  1. Connect the SCS service connector to the check connector (2-pin) located under the glove box. Turn the ignition switch ON (II). The VSA activation indicator comes on then goes OFF.
  2. Press the VSA OFF switch one time before the VSA activation indicator comes on again. Check that the VSA activation indicator comes on when the steering wheel is in the straight ahead position (neutral position), and indicator goes off when the steering wheel turns right or left more than 2.5 degrees.
  3. If the VSA activation indicator does not come on or go off, perform the neutral position memorizing procedure. See MEMORIZING PROCEDUREΒ  .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.