2003 Acura 3.2TL BaseFACTORY OEM SERVICE PROCEDURE

Rotor Slip Ring

  1. Check that there is continuity between the slip rings. If there is continuity, go to next step. If there is no continuity, replace the alternator.
  2. Check that there is no continuity between each slip ring and the rotor and the rotor shaft. If there is no continuity, go to STATORΒ  test. If there is continuity, replace the alternator.
Fig 1: Identifying Rotor Components
G96J06030Courtesy of AMERICAN HONDA MOTOR CO., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.