2003 Acura 3.2CL BaseFACTORY OEM SERVICE PROCEDURE

Clutch Replacement: Notes

WARNING: This page is about a different variant/trim than selected.

Special Tools Required

  • Pressure plate compressor 07AAE-P8EA000
  • Clutch alignment shaft 07AAF-P8EA000
  • Pressure plate compressor adapter 07AAK-P8EA000
  • Ring gear holder 07LAB-PV00100 or 07924-PD20003
  • Attachment, 37 X 40 mm 07746-0010200
  • Driver 07749-0010000
NOTE: You must use the special tools required to remove and install the clutch pressure plate or you will irreversibly damage it.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.