Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Acura 3.2CL BaseFACTORY OEM SERVICE PROCEDURE
Symptom Tests: Notes
WARNING: This page is about a different variant/trim than selected.
For symptom trouble shooting index, see SYMPTOM INDEX table.
SYMPTOM INDEX
| Symptom | Perform Test |
|---|---|
| ABS Indicator Does Not Come On | A |
| ABS Indicator Does Not Go Off | B |
| VSA System Indicator Does Not Come On | C |
| VSA System Indicator Does Not Go Off | D |
| VSA Activation Indicator Does Not Come On | E |
| VSA Activation Indicator Does Not Go Off | F |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.