Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel System Pressure Release: MDX
Obtain navigation system and radio anti-theft codes from customer, and make note of selected radio presets. Remove dashboard lower cover. Remove PGM-FI main relay No. 2. Loosen fuel tank filler cap. Start engine, let it idle until it stalls. Turn the ignition off. Disconnect negative battery cable. Remove quick connect fitting cover. Place clean shop rag over quick connect fitting and release the quick connect fitting. To install, align quick connect fitting with the fuel line. Press quick connect fitting onto the line until both retainer pawls lock with a clicking sound. Install PGM-FI main relay No. 2. Reconnect the negative battery cable. Reprogram navigation system and radio anti-theft codes and radio station presets. Then perform the following:
- PCM idle relearn procedure. See PCM IDLE LEARN PROCEDURE in SELF-DIAGNOSTICS - MDX article.
- Power window control unit reset procedure. Turn ignition switch off. Turn ignition switch on. Lower drivers window down by pushing switch to the second detent position; when window reaches bottom, hold drivers window switch in the DOWN position for 2 seconds. Raise drivers window up by pulling window switch to the second detent; when the window reaches top, hold drivers window switch in UP position for 2 seconds. If the drivers window does not work in AUTO, reset power window control unit according to the above procedure again.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.