Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Acura MDX Base, MGHAFACTORY OEM SERVICE PROCEDURE
Reverse Lock System
- Check whether the scan tool indicates DTCs P1705 or P1706. Does the scan tool indicate either DTC? If yes, diagnose and repair indicated DTCs. See SELF-DIAGNOSTIC SYSTEM in MGHA DIAGNOSIS article. If no, go to next step.
- Turn ignition off.
- Shift the gearshift lever into the "P" position while pushing the shift lock release button. See Fig 1.
- Turn ignition on.
- Press the brake pedal, and do not press the accelerator pedal.
- Shift the gearshift lever out of the "P" position to check that the shift lock solenoid operates. Does the gearshift lever shift out of the "P" position? If yes, go to next step. If no, go to SHIFT INTERLOCK SYSTEMΒ .
- Turn ignition off.
- Remove the shift lock relay. See Fig 2.
- Check for continuity between the No. 1 and No. 4 terminals of the shift lock relay while connecting the battery positive terminal to the No. 5 terminal of the shift lock relay and connecting the negative terminal to the No. 3 terminal. See Fig 3. Is there no continuity when connecting the battery terminals, and continuity when disconnecting the battery terminals. If yes, go to next step. If no, replace the shift lock relay.
- Shift the gearshift lever to the "N" position.
- Check the continuity between the No. 4 terminal of the shift lock relay socket and ground. See Fig 4. Is there continuity? If no, repair open in the wire between the No. 4 terminal of shift lock relay and transaxle range switch. If yes, go to next step.
- Shift the gearshift lever out of the "N" position.
- Check for continuity between the No. 4 terminal of the shift lock relay socket and ground. Is there continuity? If yes, repair short to ground in the wire between the No. 4 terminal of the shift lock relay and the transaxle range switch. If no, go to next step.
- Check for continuity between the No. 1 terminal of the shift lock relay socket and the No. 2 terminal (White/Green wire) of the shift lock solenoid connector. See Figure and Fig 3 . Is there continuity? If yes, check for loose terminal fit in the connectors. Repair the reverse lock mechanism. If no, repair open in the wire between the No. 1 terminal of the shift lock relay and the shift lock solenoid connector.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
