Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Acura MDX Base, MGHAFACTORY OEM SERVICE PROCEDURE
Key Interlock System
- Remove screws from lower steering column cover. Remove upper and lower steering column covers. Disconnect the key switch connector (7 pin) from the steering lock assembly.
- Connect the No. 7 terminal of the key switch connector to the battery positive terminal, and connect the No. 5 terminal to the battery negative terminal. See Fig 1.
- Turn the ignition switch to ACC position, then push the ignition key.
- Check the key interlock solenoid operation. A clicking sound should be heard while pushing the ignition key. You should not be able to turn it to the OFF position. Does the key interlock solenoid operate properly? If yes, go to next step. If no, the key interlock solenoid/switch is faulty. Replace the ignition key cylinder/steering lock assembly. See appropriate STEERING COLUMNS article in STEERING.
- Measure the voltage between the key switch harness connector No. 7 terminal and ground. Is there battery voltage? If yes, go to next step. If no, check for a blown No. 47 (20 amp) fuse in the underhood fuse/relay box. If the fuse is okay, repair open or short in the wire between the No. 7 terminal of the key switch harness connector and underhood fuse/relay box.
- Disconnect the A/T shift switch assembly connector (6 pin) on the rear of the gearshift lever. See Fig 2. To gain access to A/T shift switch assembly connector (6 pin), remove center console. See CENTER CONSOLEΒ under REMOVAL & INSTALLATION.
- With the gearshift lever in Park and pushed to the right, check for continuity between the No. 2 and 4 terminals of the A/T shift switch assembly component connector (6 pin). Is there continuity? If yes, go to next step. If no, repair open in the wires between the park pin switch and the A/T shift switch assembly connector (6 pin). See WIRING DIAGRAMSΒ . If the wires are okay, replace the detent bracket assembly (park pin switch is not available separately). See Fig 3.
- Check for continuity between the No. 4 terminal of the A/T shift switch assembly harness connector (6 pin) and the No. 5 terminal of the key switch connector. See Fig 1 and Fig 2 . Is there continuity? If yes, go to next step. If no, repair open in the wire between No. 4 terminal of the switch assembly connector (6 pin) and the No. 5 terminal of the key switch connector. See WIRING DIAGRAMSΒ .
- Check for continuity between the No. 2 terminal of the A/T shift switch assembly harness connector (6 pin) and ground. Is there continuity? If yes, check for loose terminal fit in the key switch connector and A/T shift switch assembly connector (6 pin). If necessary, substitute a known-good steering lock assembly. If no, repair open in the wire between the No. 2 terminal of the A/T shift switch assembly connector (6 pin) and ground or repair poor ground.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
