Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Acura 3.2TL BaseFACTORY OEM SERVICE PROCEDURE
Shift Lock Solenoid Test
- Remove the console panel. See Console Panel .
- Disconnect the shift lock solenoid 2P connector.
- Connect the No. 1 terminal of the shift lock solenoid connector to the battery positive terminal, and connect the No. 2 terminal to the battery negative terminal.
- Check that the shift lever can be moved from the P
position. Release the battery terminals from the shift lock solenoid connector. Move the shift lever back to the P
position, and make sure it locks.NOTE: Do not connect power to the No. 2 terminal (reverse polarity) or you will damage the diode inside the solenoid.
- Check that the shift lock releases when the release lever is pushed, and check that it locks when the release lever is released.
- If the solenoid does not work, replace it.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.